- additional debug information
- improve support for dictionary specification of constant, polynomial
and table entries. These previously only worked properly for
primitiveEntry, which causes confusion.
- extend table Function1 to include TableFile functionality.
Simplifies switching and modifying content.
Checking for the sum of species mass fraction in multiComponentMixture.
It can't be zero at the internal field or patches. A fatal error is thrown.
A warning was added if the mixture sum is different from one. In a
re-start the mass fraction can be slightly unbounded and new
normalization is required.
- in most cases this eliminates manually calculation of circumferential
points.
TUT: improve parameterization of sphere blockMeshDict
- allow separate parameterization of radius, ratio of inner to outer,
and the number of divisions in x/y/z and radial directions
Adding reflecting fluxes to Solar load radiation model.
Adding functionality to the boundary radiation models and new
place holder for basic wall types such as transparent, opaqueDiffusive,
opaqueReflective,etc.
Changing radiation wall models to run time selectable.
Adding multi-band capabilities to VF model and improving the set up
for using solar loads in VF and fvDOM radiation models.
- helps reduce clutter in the topoSetDict files.
Caveats when using this.
The older specification styles using "name" will conflict with the
set name. Eg,
{
name f0
type faceSet;
action add;
source patchToFace;
sourceInfo
{
name inlet;
}
}
would flattened to the following
{
name f0
type faceSet;
action add;
source patchToFace;
name inlet;
}
which overwrites the "name" used for the faceSet.
The solution is to use the updated syntax:
{
name f0
type faceSet;
action add;
source patchToFace;
patch inlet;
}
- old 'DELETE' enum was easily confused with 'REMOVE', which removes
the set, not the elements from the set.
- provide corresponding subtractSet() method
STYLE: HashSet set/unset instead of insert/erase methods in topoSetSource
- simplifies switching to/from bitSet storage
- improve doxygen entries for searchable surfaces.
- support selection of searchable surfaces with shorter names.
Eg,
type box | cylinder | ...;
vs type searchableBox | searchableCylinder | ...;
Support the following expansions when they occur at the start of a
string:
Short-form Equivalent
========= ===========
<etc>/ ~OpenFOAM/ (as per foamEtcFile)
<case>/ $FOAM_CASE/
<constant>/ $FOAM_CASE/constant/
<system>/ $FOAM_CASE/system/
These can be used in fileName expansions to improve clarity and reduce
some typing
"<constant>/reactions" vs "$FOAM_CASE/constant/reactions"
Within decomposeParDict, it is now possible to specify a different
decomposition method, methods coefficients or number of subdomains
for each region individually.
The top-level numberOfSubdomains remains mandatory, since this
specifies the number of domains for the entire simulation.
The individual regions may use the same number or fewer domains.
Any optional method coefficients can be specified in a general
"coeffs" entry or a method-specific one, eg "metisCoeffs".
For multiLevel, only the method-specific "multiLevelCoeffs" dictionary
is used, and is also mandatory.
----
ENH: shortcut specification for multiLevel.
In addition to the longer dictionary form, it is also possible to
use a shorter notation for multiLevel decomposition when the same
decomposition method applies to each level.
